Permet de transmettre 1 port Ethernet 10/100Base-T sur 1 Port E1 (120 Ohms/75Omhs) non tramé.
The E1 to Ethernet protocol Converter is a device that extends Ethernet by means of telecommunication lines (E1 or E1 transport network, such as PDH, SDH, or microwave, etc.) and is also referred to “Net Bridge".
It can effectively utilize free bandwidth of telecom operators’ lines and can be used instantly once it is deployed, with little increased investment.
Power : 220V±20% , -36 ~ -72V
Power Consumption : < 5W
Environment Temperature : 0℃-50℃ -> Size : 483×175×35mm or 483×160×45mm
Net Weight : 900g Packing List
TSM-E1/ETH E1/10(100)BaseT Protocol Converter
One Power cord (Note : -48v no with power cord)
Two BNC Coaxial Connector -> Manual book
Transparent transmission of Ethernet data through E1 lines at 2048Kbps bandwidth
Plug and play, without any setting or debugging work
Support automatic negotiation feature in Ethernet and full duplex/half duplex mode
Support transmission of Jumbo Frames specified in IEEE 802.1Q and Ethernet switches with VLAN capability
Local data frame filtering
Provide unbalanced 75Ω and balanced 120Ω E1 interfaces
Interface Specifications E1 Interface: -> Support ITU-T G.703
HDB3 line coding, comply indication output of route warn -> Coding rate : 2048Kbps±50ppm -> 75Ω physics interface use
BNC standard coaxial connector, 120Ω physics interface use RJ45 connector Ethernet Interface:
Fully IEEE 802.3 (2000) compliant
Bit rate: 10Mbps or 100Mbps
Interface type: RJ45
Fiche technique: PDF